Built to work season after season, this non-rolling tower delivers a wide 7′ deck and rust-fighting protection everywhere it matters.
You’re getting a three-section ladder stack with 7′ bracing and a full deck of severe-duty 7′ aluminum-plywood walkboards. Braces and hardware are galvanized inside and out to help block rust in the tube interiors, and the ladder frames wear a tough powder-coat that shrugs off everyday knocks. Base plates keep the tower fixed, while the 5′ × 7′ BreakDown Guardrail System helps you work safe at height.
What’s working for you
- Severe-Duty 7′ Walkboards: Aluminum side rails + exterior-grade plywood deck feel planted underfoot; the integrated wind-latch helps keep boards seated. Three boards span the bay for a full 7′ platform.
- 5′ × 7′ BreakDown Guardrail System: Top/mid rails and posts go together fast and break down for transport—simple, commonsense protection when you’re working at height.
- Base Plates: Provide a fixed, non-rolling footprint that spreads load and reduces shimmy on firm, level surfaces.
- Climb-Friendly Frames: Familiar ladder-style access between levels; durable finish stands up to jobsite life.
Setup & Safety Tips
- At ~15 ft, go wider: Add Outriggers—even on stationary builds—especially if floors are uneven or slick.
- Guardrails on? Many jobsites also require Toeboards to help keep tools and materials from stepping off the edge.
- Thinking about rolling later? If you add casters, include a Grouser Bar to tie frames together for stability while you move.
Key Features
- Full 7′ Deck: Three severe-duty walkboards deliver a broad, stable work surface.
- Rust Defense: Galvanized braces & hardware—tube interiors included—help extend service life.
- Planted Stability: Base plates keep your tower fixed and confident underfoot.
- Grows with You: Add height, outriggers, and toeboards as jobs demand—or convert to rolling with casters and a Grouser Bar.
Important Notes
- For taller builds or uneven/slick floors, add Outriggers to widen the footprint.
- If you later add casters to this stationary tower, also add a Grouser Bar to tie frames together for rolling work.
- Some competitor braces aren’t coated internally. If there are no small vent holes near the brace ends, the interior may not be galvanized and can rust over time.
